Dbx 223xs

dbx dbx223xs
crossover

dbx ® crossover 223xs garantisce grandi prestazioni, basso rumore e affidabilità. la straordinaria precisione dei filtri utilizzati consente di indirizzare ai driver solo la corretta parte di spettro e permette così agli amplificatori di funzionare alle massime prestazioni senza distorsioni, garantendo al proprio sistema pa di generare un suono pulito e preciso. ingressi uscite crossover stereo mode mono mode sistema signal-to-noise 

input connectors xlr (pin 2 hot)

input type electronically balanced/unbalanced, rf filtered

input impedance balanced >50k ohm, unbalanced >25k ohm

max input >+22dbu balanced or unbalanced

cmrr >40db, typically >55db at 1khz

output connectors xlr

output type impedance-balanaced/unbalanced, rf filtered

output impedance balanced 200 ohm, unbalanced 100 ohm

max output >+21dbu balanced/unbalanced into 2k ohms or greater

bandwidth 20hz to 20khz, +/-0.5db

frequency response < 3 hz to > 90 khz, +0/-3 db

signal to noise ratio ref: +4 dbu, 22 khz measurement bandwidth

signal-to-noise (stereo mode) >94db (low output), >91db (high output)

signal-to-noise (mono mode) >94db (low output), >93db (mid output), >91db (high output)

dynamic range > 106 db, unweighted, any output

thd+noise < 0.004% at +4 dbu, 1 khz; < 0.04% at +20 dbu, 1 khz

interchannel crosstalk < -80 db, 20 hz to 20 khz

crossover frequencies (stereo mode) low/high: 45 to 960 hz or 450 hz to 9.6 khz (x10 setting)

crossover frequencies (mono mode) low/mid: 45 to 960 hz or 450 hz to 9.6 khz (x10 setting); mid/high: 45 to 960 hz or 450 hz to 9.6 khz (x10 setting)

crossover filter type linkwitz-riley, 24 db/octave, state-variable

low cut switch activates 40 hz butterworth, 12 db/octave high-pass filter, one switch per channel.

phase invert switch inverts the phase at the output, one switch per output.

x1 / x10 switch multiplies the low-high(mono: low/mid and high/mid) crossover frequency range of the front-panel markings by a factor of 1 or 10, one switch per channel.

mode switch selects stereo/mono and 2/3-way operation

lf sum switch selects normal (stereo) or mono-summed low frequency operation and disables ch 2’s low output phase invert led to indicate that this output is not operational in the lf sum mode.

indicators stereo operation (green); mono operation (yellow); low cut (red-per channel); x10 (green-per channel); phase invert (red-per output)

operating voltage 100 vac 50/60 hz; 120 vac 60 hz 230 vac50 hz

operating temperature 32°f to 113°f (0°c to 45°c)

power consumption 15w

power connector iec receptacle

dimensioni (l x h x p): 48,3 x 4,4 x 17,5 cm

peso: 1,7 kg